Receive a call

Theorically working on all EZX phones, tested on A780 only.

When you receive a call, the BP will send a message on the mux line 0.

Assuming you followed the "CALL" page and had success to:

• insert your PIN code
• register the network
• setup alsamixer

Procedure

• To listen to the mux line 0 and wait for a call, use:

cat /dev/mux0

• If the caller's phone number is XXXXXXXXX, you'll read this:

+CLIP: "XXXXXXXXXX",129

• To accept the call, close the "cat", or use a second terminal session, then:

echo -en "ATA\r\n" | nc localhost 7100

• Hangup:

echo -en "ATH\r\n" | nc localhost 7100